![]() (Use a soft face hammer to avoid damaging top of bolt or slide). 5 L Drive bolt back into slide until retaining pin holes in side and bolt are aligned. Pull slide back slightly, approximately 1/4", so bolt can be inserted into top of slide. ![]() Pull slide back over the barrel, then down and back. Insert front of recoil spring into spring hole at front of slide. RE-ASSEMBL V Replace recoil rod and spring into recoil rod hole in frame. 2, Slide will come forward off of frame, no other disassembly is necessary. If it becomes necessary to disassemble for cleaning the procedures are as follows - j, Remove bolt pin with a 1/8" diameter punch, pull slide back approximately 1/2" so firing pin and spring will come out of bolt, then remove bolt by inserting a brass or aluminum rod into magazine well and drive bolt out of slide. Oil slide rails and outside diameter of barrel where it rides in frontof the slide. to clean and lubricate, This can be done by pulling the slide back all the way to the rear position, then run a cleaning rod with a solvent coated patch through bore and chamber, then run a clean, dry patch through until clean. ![]() T AKEDOWN FOR CLEANING Before you start, be absolutely certain that the pistol is unloaded by following the unloading instruction on page 5.
0 Comments
Leave a Reply. |